Yeah... The market is still shifting in response to the X1C.
10 years ago... I would manually level my ender, religiously monitor it, and still deal with a decently high failure rate (esp for anything other than PLA). Tuning the printer took easily as much time as I actually spent printing with it. I upgraded all the things, flashed firmware, ran octoprint, etc...
It was like driving - gotta keep the hands on the wheel and maintain alertness at all times. It was an activity that required my attention and focus.
Then I caved and got an X1C in 2023. It's... a really, REALLY good machine.
It's like flying somewhere. I get on the plane, start up a movie or a book, and someone wakes me up when the flight is over. It's a tool that is doing things for me while I do other stuff.
I'm at the point where I'm not really interested in the "middle" all that much. Either go with a Voron and get the "I'm driving" feeling if that's what you want. Or get a Bambu and get chauffeured to successful print.
I agree entirely with your first two sentences (I like both).
But I disagree pretty hard with the rest of it. An X1C spits out prints that are higher quality than my ender 3 would do, in a variety of materials the ender couldn't handle, even with a HUGE amount of time understanding the ender and how it works (incl upgrading or replacing just about every component).
Further - I think some of the divide is between the folks printing models, and the folks printing functional parts.
When I print nice models (ex: toys for my kids or gifts) then sure - I tweak still because appearances matter.
But if I just want a functional print because I need an enclosure for an electronics project, or I want a hanger for my wall, or I need a new footpad for a desk... Mediocre is a-ok.
And again... The X1C is not spitting out mostly mediocre parts. If anything - the "learning" you need to do mostly lives in the slicers/models at this point.
10 years ago... I would manually level my ender, religiously monitor it, and still deal with a decently high failure rate (esp for anything other than PLA). Tuning the printer took easily as much time as I actually spent printing with it. I upgraded all the things, flashed firmware, ran octoprint, etc...
It was like driving - gotta keep the hands on the wheel and maintain alertness at all times. It was an activity that required my attention and focus.
Then I caved and got an X1C in 2023. It's... a really, REALLY good machine.
It's like flying somewhere. I get on the plane, start up a movie or a book, and someone wakes me up when the flight is over. It's a tool that is doing things for me while I do other stuff.
I'm at the point where I'm not really interested in the "middle" all that much. Either go with a Voron and get the "I'm driving" feeling if that's what you want. Or get a Bambu and get chauffeured to successful print.