For me, the whole thing is an impressive flex, but I know next to nothing about electronics. Can you elaborate what’s interesting about using 555 timers in particular?
The 555 timer is considered one of the most successful chip designs in electronics. It has a simple, well understood, design. The timing on the 555 can be configured to generate a periodic signal using just a few resistors and capacitors. The 555 is often used as a timer in electronic circuits. The Linux scheduler is usually configured to respond to interrupts generated by a cpu. To replace those cpu interrupts by a simple 555 timer is impressive due to the unconventional nature of the setup.
Also, the 555 is an ancient chip, that pretty much appeared as the basic chip (along with it's friend, the 741 general purpose op-amp), being the two of them the protagonists of pretty much 70% of the hobby circuits in the 80s.
I don't think it's a flex per se, but more of a nod to where many people start off in their electronics careers. The LM555 has been used for four(?) decades to teach electronics to students.
A cheap $1 8-pin microcontroller (attiny, avr8, pic) could do the job of an LM555 without the LM555's required capacitors/resistors. But that's not as fun.
There's a bit of a meme among electronics hobbyists that for so many projects with an Arduino, somebody in the comments says "I could've done that with a 555”. It's a very common chip with a wide range of uses from arcade sound generation to the timer on a toaster to light/motion activated alarms.
As someone that grew up reading Elektor articles, that pretty much sums up most of the gadgets I see on Maker magazines.
The big difference is that is much easier to program a microcontroller in software, than mastering electronics, specially when analogue circuits are evolved, and the only debugging tools are a multimeter, pen and paper.
I've seen it often on Hackaday over the years, and while they probably could do it all with a 555, I certainly couldn't... My specialties are software and mechanical stuff, for everything in-between I shove in an Arduino and hope it works!
